This tutorial will take you through the steps to get your RAK Wireless 831 Lora concentrator board up and running on the RPi Zero W.
The Snickerdoodle is an SoC, with processors and programmable logic. Let's look at how we can accelerate Python with PYNQ on it!
Typewriter sounds, animated words and ASCII pictures for this Raspberry Pi based Gonzo tribute art installation
Why not put a Raspberry Pi into a 2007 netbook?
This project walks through installing Ubuntu 20.04.3 Desktop on the Kria KV260 Vision AI Starter Kit and using Edge Impulse with it.
This project walks through how to implement and use SPI in embedded Linux via the spidev kernel on the Zynq-7000 using PetaLinux 2022.1.
Latency optimization on running critical thread can be done by using RT Patch on MPSoC & for thread priorities CPU Isolation can be used.
Booting Embedded Linux images on Zynq UltraScale+ MPSoC from the JTAG interface using the XSCT utility provided by Xilinx
This project walks through the basics of creating your own ML model in Edge Impulse & deploying it on the Kria KV260.
This project walks through the installation of Vitis and PetaLinux 2022.1 as well as KRS 1.0 on Ubuntu 22.04 Jammy Jellyfish.
This project walks through how to install AMD's FPGA development tools on Ubuntu 20.04 & 22.04 LTS.
Want to learn about DMA and Linux Drivers? Create your own Linux Kernel Module to transfer data between PS and PL using this learning guide.
iNap Malinka is a Raspberry based handheld with the NRF24L01+PA+LNA radio module, running RetroPie!
Communicate with ESP32 over Internet using command line interface to save network credentials in the non-volatile memory and control LED.
Complete flow from scratch: Vivado platform, Petalinux build and hardware kernel build on Vitis, on the MYIR development board MYD-CZU4EV
Arduino MKR1000 as a HID, for performing HID penetration testing over WiFi networks.
Adding Yocto project on RPI3 and adding NAS Server on RPI3
This project walks through how to create an embedded Linux image for the Arty-Z7 using PetaLinux 2022.1
I installed various EE design applications on the Ubuntu 22.04 desktop image of my KV260 including KiCad, and laid out a custom PCB with it.
A simple demo to show how to write an ISR on a BBB in Python running Debian.
Making the Honda Awareness AI Traffic Light from scratch with Edge Impulse
How to create and leverage embedded Linux in small FPGAs using MicroBlaze
This project lets you configure the Omega2+ to boot to the Micro SD card. Just run a single script!
With the OSD335x C-SiP, the Complete System-in-Package device, you can solder your own Linux computer with just a few resistors and wires.
